RUST CONTACT V (FLOSIL RCV)
/

Rust Converter & Encapsulator

Product Description

A single-component, water based rust converter cum encapsulater containing polymer-based encapsulating system that reacts with tightly adherent residual rust providing clean, suitable and noninvasive surface for subsequent coating system’s adhesion to the substrate. Contact V is a Non-Hazardous, Non-Toxic and Non-Flammable material. Since it is water based, it is safe to be transported by air.

  • Rust Conversion
  • Encapsulate Rust
  • Surface Sealing
  • Water Based
  • Easy To Apply
  • Excellent Corrosion Resistance
Colour Off White to Grey
Finish Matt
Volume Solids 43% ± 3%
Mixing Ratio Single Pack
Pot Life Unlimited
Typical Film Thickness 65-90μ dry (150-200μ wet)
Theoretical Coverage 6.6 Sq.m/liter at 65μ DFT
Method of Application Brush, Roller, Spray, Flooding
Touch Dry 30 minutes
Dry to Handle @ 30°C 24 Hours
Hard Dry 60 minutes @ 30°C
  • This product should be coated with only approved products and only after conforming full cure.
  • The surface of Contact V post curing shall be free from visible contaminants such as oil, grease, dust, dirt, paint chips etc.
  • Fresh water washing may be conducted post cure in order to remove any residual non-visible contaminants such as chemical salts.

Systems and Compatibility

Contact V maybe over coated with - AQUA SEALER, AQUA ST, AQUA ST-03.

Please consult Flosil-BET Coatings for products of other manufacturers and their compatibility with Contact V.

Possible Applications

  • As a “Base Coat” when abrasive blasting or thorough surface preparation is not possible
  • As a primer for Flange Protection System
  • As a penetrating and sealing agent for porous substrates
  • As an “Etch Primer” for non-ferrous substrates
Air Temperature 5-55°C
Substrate Temperature 5-60°C
Relative Humidity 50% minimum, 85% maximum
Surface temperature shall always be at least 3°C above Dew Point. Do not expose the coated articles where there are chances of condensation on the surface.

Mixing

Contact V is a single component product hence no mixing ratio is applicable.

Stir the contents of can thoroughly as slight settling may be expected upon prolonged storage. Cans once opened shall be utilized first.

Thinning

Do not thin.

Airless Spray

Recommended. Tip Size 0.48 – 0.53mm

Conventional Spray

Recommended. Do not exceed spray pressure than 4 Kg/Sq.Cm

Brush / Roller

Recommended. Ensure to choose brush or roller size according to the substrate. Stripe coat well on the welds, edges, corners and crevices before carrying out full coat application.

Available worldwide through Flosil-BET Coatings (India) Pvt Ltd. and their authorized agents.

Standard Packing Size: 2L & 0.5L

Do not expose to freezing conditions. Optimum storage temperature should not exceed 50°C.

*Material to be stored in sealed and unopened containers in closed shelter.

Rusted surface before Contact V

Rusted surface after Contact V

Rusted Surface before Contact V

Rusted Surface after Contact V

Rusted surface after first coat of Contact V

Rusted surface after application of
Contact V & Aqua Sealer

Rusted Surface before Contact V

Rusted Surface after Contact V

CONTACT /
GET IN TOUCH WITH US
Flosil-BET

No:40, Velichai Village,
Vandalur – Kelambakkam Road,
Chennai – 600 048.