Zero Incident Anti-Slip Coating | SKIDFREE® - ANTI SKID (FLOSIL SKIDFREE®)

The SKIDFREE^® anti-skid system designed, produced by Flosil-BET is an innovative product to prevent accidents/incidents due to skidding.

The proprietary SKIDFREE^® anti-skid system has been designed in a way that prevents falls and slips usually associated with staircases, ladders and accesses.

Product Information
Overcoating Condition
Performance Data
Application Data
Availablity & Packing Size

Colour	All RAL, BS Colours
Finish	Glossy, Semi Glossy, Matt
Volume Solids	90 ± 3%
Mixing Ratio	1:1 By Volume (Part A : Part B)
Typical Film Thickness	150μm dry
Pot Life	90 minutes @ 35°C
Theoretical Coverage	3.8 Sq.m /liter at 250μ DFT
Method of Application	Roller, Brush
Touch Dry	4-6 hours
Hard Dry	12 hours @ 30°C
Full Cure	3 Days

Minimum Over-coating Period	4 hours at 30°C
Maximum Over-coating Period	72 hours at 30°C
Surface should be clean and dry prior to over-coating. If ANTI-SKID has been exposed for long periods, fresh water washing should be conducted before application of any coatings.

Systems and Compatibility

Can be applied as finish coat on AQUA SEALER, AQUA ST, AQUA ST-03, AQUA MASTIC.
Please consult Flosil-BET Coatings (India) Pvt Ltd for further product recommendations.

Abrasion Resistance	Max 70mg weight loss per 1000 cycles - 1kg load - CS10 Wheel - ASTM D4060
Impact Resistance	27 Joule - ASTM D2794
Dry Heat Resistance	120° C - ASTM D2485 after full cure
Pull - Off Adhesion	10.66 Mpa - ASTM D4541
Scratch Hardness	12.5 kg Load - No Failure - (BS3900 Part E2)
Salt Fog Resistance	Excellent, Unaffected after 2000 hr Exposure - ASTM B117
Cyclic Fog / UV Exposure	Excellent, Unaffected after 2000 hr Exposure - ASTM 5894-05

POSSIBLE APPLICATIONS

Marine and Offshore Gangway areas and railings
Industrial Floor Coatings
Stair Case Slip protection
Industrial structural Gangways
Hospitals
Play Area, Stadiums
Bathroom Flooring

Air Temperature	5-50°C
Substrate Temperature	5-55°C
Relative Humidity	50% minimum, 90% maximum
Surface temperature shall always be at least 3°C above Dew Point. Do not expose the coated articles where there are chances of condensation on the surface.

Mixing

ANTI-SKID is supplied in 2 parts, a liquid binder (Part A) and a liquid binder (Part B). Always mix liquid (Part B) into the liquid (Part A) while stirring. 75-100 RPM mixer is recommended.